Instructions: Hookwall Set Down Packer
To Order Call Steve Boone,
(304) 422-6525 or (800) 642-1991
Catalog Revision April 2004
Newly Designed & Fully Machined
Casing Heads & Tubing Heads
SETTING AND PULLING INSTRUCTIONS
PARMACO HOOKWALL SET DOWN PACKERS
ORIENTATION AND USE
This packer is run with the neoprene element at the top of the packer. The packer sets in a downward movement due to the weight of the tubing. It is suitable for setting in open hole or casing.
RUNNING AND SETTING INSTRUCTIONS
While running packer in the hole, take care not to turn the packer. The last move of the packer before starting the setting operation must be upward – approximately one foot.
The packer is set by turning one half turn to the left (counter clockwise looking down) then lower to engage the slips and neoprene. The weight of the tubing causes the slips to wedge against the wall and expands the neoprene to affect the seal.
Pull tubing and retrieve packer. No preparatory steps are required.
In the event a packer is to be used in acidizing a well, care should be taken to pull the packer after acidizing in order to prevent the seizing of packer components due to corrosive action. Otherwise, difficulty could be encountered later in pulling the packer.
REMOVE WIRE FROM SLIPS BEFORE RUNNING PACKER!