Instructions: Standard Tension Packer
To Order Call Steve Boone,
(304) 422-6525 or (800) 642-1991
Newly Designed & Fully Machined
Casing Heads & Tubing Heads
SETTING AND PULLING INSTRUCTIONS
PARMACO SHEAR TENSION SET PACKER
Run the packer to desired depth. Establish true pick up and slack off weights. Make last tubing movement down, rotate the tubing ¼ turn to the right at the packer, pick up on the tubing to set the slips and establish packoff. Pull sufficient tension to produce a tight seal (see chart below).
SETTING FORCE GUIDE
Minimum Force (lb.) Required at Packer
To release the packer, lower the tubing to automatically lock the J-control system in the running position.
SAFETY RELEASING PROCEDURE
If the packer cannot be released, additional tension is pulled, shearing the shear pins in the bottom of the packer. This allows the cone to move down, freeing the slips. A left-hand safety coupling also allows the tubing to be released from the packer. This is accomplished by rotating the tubing to the right approximately 15 turns at the packer.